B Body Mopar B Body Mopar forum

need some help/ideas

Gary_gtx67
06-30-2010, 03:10 PM
Guys i need some help/ideas. I have a 67 gtx clone-383 .30 over keith black hyper utetic pistons comp 280 cam edelebrock rpm performer intake holley 750 doublepumper and a hughes 2800 stall coverter. what gear would i need to run im the 1/8th to see a high 7 sec? should i try a little nitrous as well?

poppaj
06-30-2010, 09:51 PM
I would run a 4.30 in it. It should be down in the 7.30 range with a decent 3800-4000 stall converter with slicks.

Gary_gtx67
07-01-2010, 05:35 AM
Really! Sweet! :D

Gary_gtx67
07-02-2010, 10:30 AM
I forgot to mention that I had the heads shaved down and over sized valves with hardens seats and triple comp springs. Compression is a 10-2-1 ratio.

383man
07-11-2010, 10:56 PM
I would run a 4.30 in it. It should be down in the 7.30 range with a decent 3800-4000 stall converter with slicks.


I dont think you will get near the 7.30 area as thats 11.50's. I would think more like high 7's unless you use some nitrous. How tall of a tire are you running ? Ron

ykf7b0
07-12-2010, 10:19 AM
I agree. You are probably looking at low to mid 8's with a 4:57. If you decide to inject nitrous, make sure you have consistent fuel pressure. Best of Luck to you!

SUPERSTOCKRACER
07-13-2010, 07:39 PM
4.56 gear would get ytou close but you'll be a little shy of your goal.imo.

poppaj
07-15-2010, 02:34 PM
I helped a fellow over here with a 67' Satellite it was a .030 over 383. hydraulic purple shaft, trw slugs with a torker/800 holley, .430 gears, 3800 hughes converter. With some tuning it ran a best of 7.36. It also had 9" slicks. It is a very consistant car.

RacerAL
07-15-2010, 08:21 PM
when i first was getting my car running(67 Satty), i went 8.0's with a early 70's RV 413 prolly(8.25to1) if it was lucky..with a 484 MP cam and a 3500 stall conv. with a 30 inch tall slick and 4.10 gear. my car was a bit lighter then as i didn't have the interior finished and a few other things..still had to be somewhere around 3600lb. now it runs 7 teens and weighs 3675...do you know what your car weighs?..i agree with whats been said you prolly will want 4.56's..as long as your NOT gonna spray it..and if you don't spray it, i have my doubts that it will go in the 7's. i'm guessing 8.0's to 8.20's. NOW if you are gonna spray it i would use 4.10's. i guess it sorta depends on how much spray your gonna use..i would think i 150 shot would get you close to your goal. GOOD LUCK
http://i228.photobucket.com/albums/ee69/racerAL_2007/Picture028.jpg

lazermule
07-28-2010, 12:33 PM
I dont think you will get near the 7.30 area as thats 11.50's. I would think more like high 7's unless you use some nitrous. How tall of a tire are you running ? Ron

I wouldn't recommend running too much Nitrous on those KB "Hyper-Explosive" slugs.... Pretty good pistons, but I would recommend forged only for Nitrous..IMO

LM