Studs heads mains

do you guys free float (leave them 1/4 turn loose) them into the block or lock them down into the threads?

i snug and locktite as i dont want to stretch the stud before i fasten the heads or caps

How would one stretch a stud threading it into the block?

I think the free float method would be best. This would allow you to align the stud to the spot face on the head under the nut before torquing. A little pipe thread sealant on the threads for the blocks that hit water would be a good idea too.

i snug and locktite

Ditto. Never had any problems.

FWIW

KB INDY and BAE all told me to snug/tighten them in NO LOCTITE, just wanted to double check what I was doing. Thanks anyway.

FWIW

KB INDY and BAE all told me to snug/tighten them in NO LOCTITE, just wanted to double check what I was doing. Thanks anyway.

Damn. I'm a moron. Not Locite - I used the moly lube (little white packet) that comes with the ARP Studs. Sorry for the confusion.

Ray

acme do you know Ritchie Cotto?

acme do you know Ritchie Cotto?

You asked me that previously but apparently did not see my reply...which was no, I don't think so - but should I? Local guy I am guessing???

Ray