P/S bracket issue..Ahh help

Hey guys, posted this on another site and no luck, thought id try asking here.
Ok so ive got about a 69 440-block ,an Alum Mopar housing and I bought a p/s pump with brackets from ebay and they dont line up....The brackets seem to be too wide for the housing (see pic below) and definitly doesnt line up the belts. I just figure it must need a diff config of brackets ...Any suggestions would help a ton.thx
72Satellite440-Dan
http://img151.imageshack.us/img151/7524/090mo.th.jpg (http://img151.imageshack.us/i/090mo.jpg/)
http://img836.imageshack.us/img836/3387/089uc.th.jpg (http://img836.imageshack.us/i/089uc.jpg/)
http://img18.imageshack.us/img18/2041/091rm.th.jpg (http://img18.imageshack.us/i/091rm.jpg/)

as far as i can tell from the pictures,those don't look like the right brackets.maybe somebody else here would have a photo of theirs and you can compare them.i don't have any myself right now.

72Sat, thanks for the help on the cooling system.

I will take a picture of mine tonight and post it for you - the bracket does not seem correct. I do not have that problem.

Ralph

72 sat, here are your photos on a 73 RR.

two sets of photos

Last two

Can you post pic's of the p/s pump out of the car?

Here are some bracket styles have a look.

HF-PS001
1969-later All Big Block models w/o air
for Saginaw style pumps

23875

HF-PS004
1970-Up All Small Block models w/ or w/o AC
for Saginaw style pumps

23876

HF-PS003
Most 1969-down models (non-AC cars) - Big Block & Hemi
for TRW/Thompson style Federal style pumps w/ large notch (illustration A below) [not for original style Federal pumps; see illustration below to define which type you have] (must have 1-3/4" body to pulley distance for these brackets to work

23877

HF-PS005
Most 1967-72 Big Block & Hemi models w/ or w/o AC
For Federal style pumps w/ small notch (illustration B below)

23878

HF-PS006
1970-72 Small Block models w/ or w/o AC
For Federal style [aluminum water pumps only]

23878

After looking your pic's over better I see you have a drivers side lower hose,that housing is different My "C" body 440 has that style..Most drop down on the passengers side....That might be the problem you need brackets from a "C" body 440.....My "B" body 440 has the lower passengers side hose and so do both of my buds "B" body 440's......And or....Your brackets might be for an A/C set up,if so your missing 2 brackets that might take up the open space you have.

Thx alot ralph and 74 sundance for the pics and posting- I definitly need a different type thats for sure... My front bracket has no indents in it like both of yours...must be for a ac car prob from a e body...in any case thank you for all the help :)
Little wasted $ on the p/s pump i wont need but im sure it happens to us all...sigh

Check the link and compare
http://www.billrolikenterprises.com/products.asp?cat=26&pg=4

72 Sat, looks like the rear bracket on your PS pump is angled and pushing it too far forward towards the radiator

Ralph