Hemi aluminum seat brackets

Hi, does anyone have the deminsions or patterns for A100 hemi seat brackets, i need to build a pair for my 64 savoy. Thanks.

There is a guy that goes by the name "the silverfox" that might have them, I can not find his email address but it was from AOL last time I contacted him.

You might try to Email the guy that has the seats on eBay right now.


The silverfox had a New Keith Black webber carb and manifold setup for a 426 hemi, for sale all over the place.

Hello
I have a set that was copied from a Original A-990 aluminum front end car. Good buddy of mine sold it to Englehart (sp) several years ago, and made a couple copies...The set he gave me are not finished. They have the lighting hole piloted but undrilled. But still, If you want I can throw up a few pics, and break out a tape measure.

Bob

Hello
I have a set that was copied from a Original A-990 aluminum front end car. Good buddy of mine sold it to Englehart (sp) several years ago, and made a couple copies...The set he gave me are not finished. They have the lighting hole piloted but undrilled. But still, If you want I can throw up a few pics, and break out a tape measure.

Bob

Hi, man i sure wish you could post pics. and measurements, thanks.

Here you go guys....Let me know if you have any other questions, or need diff pics.

Bob C

http://board.moparts.org/ubbthreads/showflat.php?Cat=0&Number=4909889&an=0&page=0#Post4909889

Here you go guys....Let me know if you have any other questions, or need diff pics.

Bob C

http://board.moparts.org/ubbthreads/showflat.php?Cat=0&Number=4909889&an=0&page=0#Post4909889


Thanks, this is just what i needed!

Rapid_Transit, are these seat brackets all supposed to be the same size? Is one side higher than the other? Someone please school me on this, thanks.