Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I have always wanted to try to mount this under the 1970 super bee hood that has the pitch fork hood scoops in the center. it looks like it wouldn't take too much modification and should function the same. anyone try this?
I have same issue, mine would blow when i used turn signal, I could wiggle turn signal and horn would blow. figured it was grounding out someplace but have not taken it apart yet.
I think that is correct, the guy wasnt too sure, he remembered those numbers but didnt know what they applied to.
I did find the receipt for the kb 236 pistons though
should I assume he already put thicker gaskets on if I'm only gettig 155 psi on cylinders
I guess I back off timing to...
I found additional info on engine
kb-236-.060 keith black
455 lift with 1.5 rockers 108int-114ex duration. I added 1.6 rockers so about 485 lift now
head casting number 3751213
thanks for replies
its been a while since I did the compression test, but I;m pretty sure I did it with throttle open and plugs out.
I will try the race gas to see how far I can advance it and if I get more power out of it.
I've heard you can run a colder plug also.
another guy I talked to ran...
looking for a little help with 440 engine in the super bee I bought
I dont have a lot of info on the cam used
this is what I do know
440 bored .060 over
the heads are from a 73-73 motor home no porting visible on intake or exhaust ports
heads were re-furbished and have the hardened seats...
I am rebuilding a clucth type suregrip that has broken gears. Dr.Diff has a replacement gear kit with all the gears for $175
but the carrier case has four of the alignment tabs broken off around the outside perimeter. will it still be ok to run.
thanks for replies
I get a 10% Mancini discount every other month and might give it a try.
I have the orange now and works fine but I keep hearing from mopar guys at the car shows "better carry a spare"
when i check this way at the centerline of adjuster ball, the screw threads are even with rocker with no threads sticking out.
if I align straight edge with the actual contact point of cup and ball tip then the screw is up inside the rocker too far. the threads of rocker show.
had 8 and 15/16" pushrods that seem too short, had 5 threads showing on the crane rocker adjuster.
ordered a set of 9.125 now have no threads showing, shoud I not use either and maybe order the 9.030