Search results for query: *

Anyone else have this issue, and how did you remedy it? Thinking I should make a slit for it on splash guard. Anyone run into this? Thanks!

I've been looking for a part # for the original insert for the 727 gear selector lever on my 69 GTX. I've found Dorman stuff but I don't have a part # to cross reference it to. I want to make sure I get the correct one. Thanks in advance, Tim To be clear it's the selector arm on the...

Has anyone ever tried reforming rear window trim on GTX/RR rear window trim? I found out after the fact the AMD Dutchman panel isn't even close. I've got a 1/2" gap on the first radius from the corner. Not sure if I can heat it, or cut and tig it? Thanks for the help.

I'm looking for a top windshield trim piece for my 69 GTX. Located in Iowa would be ideal.

Looking for a couple pieces of Keith Black memorabilia for the garage or trophy room. Let me know what you have.

Helping a friend locate a 383 magnum for his 71 challenger 4 speed car I believe his car was built Dec so would like to keep engine period correct. Prefer complete rebuildable engine, but would consider just a short block Thanks Tim

So I thought I'd start a thread for the gun guys looking to buy sell trade ammo, or reloading components. Here's my WTB/WTT list for now .451 250-300 grain Speer Gold dot/Deep curl bullets 50-100 .400 Speer gold dot/deep curl 160-200 grain 50-100 Small rifle primers 2-300 Let the posting begin!

Can anyone give me the bore size for the center carb on a 440+6 Caliper measurement?

Can anyone give me the bore size for the center carb on a 440+6 Caliper measurement?

I'm looking for a center carb throttle shaft for a 440 6 pak carb, automatic with solenoid arm.

Looking for a 750 vac secondary Holley manual choke Thanks Tim

Looking for a manual trans bellhousing for a 4x4 truck. Looking to install a 440 in my 85 W350 Thanks Tim

I take for granted everyone doesn't know this. If you're having trouble soldering with a soldering iron, use a wet sponge or rag to wipe it when hot. It'll remove all the crud and make soldering much easier.

Anyone have a extra 50 speer Gold Dot or Deep Curl 240 gn in .429. 44 mag. Looking to buy or trade something you may need.

So I have a 85 W350 that's over charging. I've installed a relay to make sure VR gets full battery voltage. Put several new ground wires on alt. case, VR, engine, chassis, and frame. Checked voltage at alt, and ohm'd field wire. Put on a new VR. Can't figure it out. Is it possible I have a bad...

Did I see correctly AMD is finally offering 3" wider inner wheeltubs? It's long overdue if true. I guess it also depends on how well they fit also.

Looking for a 3/4 4x4. Prefer BB auto, but open to anything. Thanks Tim

I'm trying to install the dash harness on my 69 GTX, and looking for some good detailed info. The new harness doesn't have circuit #s or any kind of id tags. Some are really obvious but others not so much. Also I'd like to get the correct routing. If anyone can point me in the right direction...