Search results for query: *

Thank you Doug. That makes more sense than most of the instructions I have read. Only difference is Howard’s wants the measurements from .050 from each side of the base of the lobe as the both ramps are not symmetrical. My issue is I’m having an issue mounting the set up I own (thought I bought...

I have watched multiple videos on how to degree a cam with the heads on. All have different methods, at least for me I'm much more of a visual learner, unfortunately I find it difficult. I'll keep trying.

So I purchased a billet single bolt 9 keyway timing set for my 440. I wanted a quality billet set but didn’t want or need the nine crank slots. Just run the cam straight up. Purchased from 440 Source but turns out it’s a Summit private label part. So first thing I notice is the marks are not...

I can’t agree with your take on it Bob. I’m always fiddling with my cars and and doing subtle things to make things better in looks or performance. Usually when I complete a car to my standard or liking I move it along and look for that next project with whatever challenges it brings. My...

might you have an alternator with an april/may 69 date code?

msd is very sensitive to full battery voltage and a solid ground, both should come straight from the battery

i'm sure I can salvage what I need, really appreciate i Send me your paypal I'll shoot 50.00 dollars over to you to cover shipping and breakfast somewhere for you FYI I couldn't pm you your mail box needs to be emptied

I appreciate it but 440 source has new 1.5's in stock, 16 arms , 2 shafts, and springs for 275.00. I can't see overpaying for NOS crane. If I can't find a couple singles I'll just buy the 440 source setup.

Looking for one intake and one exhaust crane iron adjustable rockers for a 440, one left one right

what make gasket did you use?

generally speaking top radiator tank should be half full leaving room for expansion

I'll take it

good, thats ok with me, I just figured it might be special .

what is the correct type of hose that was used as the water drain tubes for the six pack base on the a12?

no the operation of the 4 turbines generate heated air

It’s my luck, I sent him a message that my hinges were already in route, he said he will try to get them done, fingers crossed

Always prep solve the entire area twice before I start spraying. I don’t know what caused it. I was wondering if there was residual solvent that I use to clean the gun after each use. That area that reacted was sprayed first. I just wonder if I sand it smooth again if I can hit it with a sealer...

I just sent the Kirker rep a bunch of photos let’s see what he thinks happened. Everything else looks fine no negative reactions and flowed out beautiful

yes I did use some reducer also. Garage temps are around 65 and I use a fuji mini mite 4 turbine system. It's fine with 1:1 or 2:1 but a 4:1 2k primer does not atomize well unless reduced

When it came to the DTM epoxy I always left it alone for a 3 day minimum. With the sandable Perfect Prime at least 24 hours.