Search results for query: *

How about a special thread of posts that mods zap. No names of posters?:thumbsup::thumbsup::thumbsup::thumbsup::thumbsup::thumbsup:

Bears are nothing to mess with. I look around when I go in backyard.

Can you afford the loss if you total or under insured? I don't want to lose $30k or $40k, risk is small. It saved me once because of a unforgivable brake job mistake I made.

Where I read that said file the stock grooves deeper starting a little off crank bearing surface down to edge. Wouldn't go crazy where it tapers down on edge. The process of thrust bearing install, I install crank and caps thrush main cap slightly tight but will shift when I take a large...

Back in 60's/70's Pro Stocker's were losing thrust bearings. The cure was as you file the oil grooves.

You may need to reuse the studs in MC.

inline tube or fine lines has a kit with a brass block and pre-bent lines. For 67 converion.

Service manual here.Service Manuals – MyMopar Seems like people forget about it.

More work to make your rig than pulling dist. How to pull and put back your distributor to prime engine. 1. Pull cap, take picture so you can see where rotor is pointing. 2. Clean base of distributor and block in a place you can reach. Take a 1/4" wide 1" or so, put the so it goes from base to...

What about an accumulator, shut it off when engine running. Shut engine down. When you go to start it open up accumulator prime engine. Pricy solution!

Get rid of the gas as has been said. I pump out all the gas out of both my cars in spring. Burn it in my DD. Then around May1 put summer gas in, the refiners in US must change the blend by then.

Don't nick the sealing surface.

Do you worry about a tire diameter mismatch with sure-grip?

I wouldn't let a buyer drive my car but I would take him for a ride. What does the buyer lose if he creates a problem? Accident or blows engine because he drives like maniac.

Why not put the other VB back to see if it work now?

:bday::bday::bday::thumbsup::drinks::drinks:cr8crshr:drinks::drinks::lol:

In 1st post the intake gasket is a different color along the top. Looks like manifold isn't compressing the gasket as much there? Would think gasket would be sucked down or is that runner where nut was?

:bday: :bday: :bday: :lol::lol: 68SptSat:lol::lol::lol:

:bday::thumbsup::bday::lol::drinks::drinks::drinks:Chewys68:drinks::drinks:

Mostly Grt Pyr he's her goof ball. He likes to lick the so they"play". Cat isn't real aggressive but he swips at him or goes where the dog can't get him.