Search results for query: *

I saw on Roadkill once that you can get a mini starter for several 80’s model Mopars that will work on a 440. Can someone tell me what that is? I have a Summit high torque starter (4 years old) and will hardly turn over after it gets hot. It also struggles a little cold now that I have 10:1...

Last drop! $400 + $35 shipping.

$300 obo.

I have a MSD dizzy for a 440 that has maybe 100 miles on it? I went back to a stock look and don’t need it. Includes all springs and bushings. $325 with free shipping to lower 48 USA only. Jacksonville fl. Sonny

I bought and installed this oil pump on my 440 2 months ago during my rebuild then realized I had bought a deep sump pan so I swapped it for a high volume pump. Never even primed it. I don’t have the gasket but the paint job is free :-). I would have returned it but I painted it. $75...

$450 or best offer. Sonny

Pic of the other snorkel. Rounded. $500 plus shipping.

It’s rounded so ‘72 and up. Thanks!!

So it doesn’t have to match the bore of the cylinder? Thanks

All I see on Summit is 4.350 and 4.375? Thanks

That looks like what I have?

Not exactly sure of the year, but this is a very good air cleaner. Both vacuum pods close and hold. Tin is new. No rust. Functions fully. Super clean unit. New filter included. In Jacksonville Florida. $600 plus $35 shipping to lower 48 USA only.

I run the trans fluid though a separate cooler not in the radiator. Thanks for responding!

New 440 rebuild. Maybe 2 miles on the engine. Runs great. A small amount of oil (tan floating solution) settles on top of antifreeze under radiator cap after a few hours of sitting. I can soak most of it out with a paper towel or two. What should my first step be to determine source?

Barely used new 440 aluminum water pump housing. No bolts or gaskets included. All threads are good. From Florida $50 plus I’ll split the shipping cost. Ship to lower 48 USA only. Paint job is free. :) Sonny

New stamped rockers, shafts, spacers and pushrods. Pushrods came from Richard Erenburg from Mopar Action mag and have balls on each end. I paid $280 total for the parts. Installed them, primed the engine and I decided to go with adjustable hp rockers, shafts, and custom length pushrods...

I know the orientation for the stamped rockers (down and out), but what about stock adjustable rockers? Same or does it matter?

So is 0.4860 the size I need?

Says not compatible with 7.2 liter?

Looking to buy or rent a bushing install tool for a 440. Can’t find the tool anywhere- all backordered and it’s starting to hold up my build. Thanks! Sonny