Search results for query: *

I'll throw this here because it's really more a question to see how others have mounted. Using the Universal system as a starting point. http://aeromotiveinc.com/products-page/fuel-systems/universal/a1000-efi-fuel-system/ already installed the sump in the tank and ordered extra fittings...

I searched the 62-65 thread for input on this. Nothing that I saw. Anybody have an opinion on preferred vendor for solid Motor Mounts. Going to a Blown Injected Hemi in the '64. I doubt the rubber ones will live. thx

Are the lower strut rods different lengths for Power steering vs. manual steering cars?'64 Dodge 330. The reason I ask is because I had the car aligned friday by an old school shop that knows his stuff. He said the best he could do was get +1* at max cam placement. (which is the spec for power...

ya can't dispute true passion for your craft.

Gents, Is there a trick to adjusting the trunk torsion springs on my '64? A special tool, a certain procedure, can it be done without help? I need to up the rod tension and fought with it for a bit then thought i'd ask. The service manual shows a special tool but I'm not even sure what it...

These are the inserts that push into the nose of the fender for the outer set of headlamp bezels on the '64 Dodge and maybe more years. They get very brittle and I would like to install new/remanufactured if anybody has a lead. I have some coming for competing brands that are close enough to...

trying to button up the splash guards and flaps today. I had these in the rubber flap kit and can't figure out where they go. Got the ones that cover the break line on each side and the square/rectangle flaps that hang from the frame and spans from the radiator saddle to the k-member. Might...

Could i get one of you guys w/ a 64 330 2DR post to take a few shots of the interior around the headliner perimeter. I am particularly interested in the transition from the headliner to the package tray cover and through the sail panel area in the rear. I know i have the garnish pieces for the...

Does anyone have the correct location and diameter of the hole for the scoop on a '64 dodge 330? i know it's offset a little but unsure of the exact location. Thanks

What's the best way to handle the plastic base for the armrests? Silver paint, re-chrome, other? It's for a 64 Dodge 330 if it matters. Thanks

Hey Guys, Getting ready to order the fabric to have the seats redone. i need to know which "direction" the the patter should run on the seats for the cloth inlays. Up and Down or Side to Side. The "stock" fabric has a woven pattern which has circles about 1/4" dia. and a small silver thread...

OK, Here we go!! Here's a couple picts to get things going... First shot is motivation...

Ok, here's the deal. I need to know the physical differance between these K memebers; /6 vs. Hemi. (64 330) I am being told that the actual K member is exactly the same, (hard to believe) the differance is the engine mounts (not hard to believe). I contacted Bob Mosher in Monrovia Ca. to do...

OK, here is are the next questions. 1) will the hood and d-lid from a 64 belvedere fit a 330 post? I know the doors and the roof line are different along with the rear quarters. 2) I need a 64/65 BB (hemi) K-Member to replace the /6 k member. I read a thread here regarding some for sale but...

Ok Gents, first post with a question. Ordered the engine saturday ('64 correct 426 Crossram hemi) from Eddie Haines for the 330, next is the trans. Does anybody here have an opinion regarding Tremec TKO 5 speed for this application. Not worried about gearing, that can be figured out later...