Search results for query: *

Took the 63 Polara to a show 70 miles away. Checked oil before we left as I always do and it was fine. Car ran fine on the way there. On the way home my wife said she thought she smelled oil burning at a traffic light. I figured it was another car in front of me. Noticed slight vibration...

Now that I actually have the max wedge tribute so I can drive it (thanks to help from people in this forum) I had serious vibration starting at around 2000 rpms and above that felt like the door panels were going to fall off LOL. Took it to a local shop and they had the driveshaft balanced. Got...

Is the correct torque for max wedge intake manifold bolts 25 ft lbs? This is with iron heads. Thanks

As a last resort to try to free stuck oil rings before pulling my motor, I tested filling each cylinder (with heads off) with various recommended chemicals and home brews just to see if any seemed to lift out deposits when pistons were rocked back and forth. Had best results with MMO then...

I recently bought a few cans of OER Classic Blend engine paint because the color was the best match for my 63 wedge intake. Carefully prepped the intake, followed the instructions, and it looked great and matched the block paint and valve covers very well. However, after installation of the...

Trying to blast carbon from my heads using 24 grit fine walnut nedia from harbor freight. My eastwood sandbaster will not allow the walnut media to come through the gun, plugs up instantly. Media is dry so the only thing I can think of is nozzle size is too small? Works fine for playground sand...

These are max wedge mopar reproduction heads P5007494. Pulled due to oil getting into combustion chambers from somewhere. Head gasket was fine and rings are good (all comp tests passed at least) so I am looking at the seals. Can anyone tell me if these look like correct seals? The umbrella one...

Does anybody know the correct valve stem seals to use on mopar performance 2406518-M reproduction max wedge heads? Original build lists Mahle B45403 and/or 45343 but Mahle stuff does not seem to be around any more? Rock Auto lists FelPro SS12419 for a 426 but they look different. Thanks!

Does anyone know where I might find a new shift cable for my 63 Polara 500, 727 pushbutton? It seems like my sleeve has cracked and no longer lubricates. Can't push the buttons until engine is fully warmed up. Looking for correct OEM or repop cable if I can find one but on some sites I can't...

Edelbrock 800 on a torker II, sitting on a 413 bored 60 over, 440 ported heads, adjustable drivetrain. Only thing I know about the cam is it is mopar, purple shaft?, and lumpy. This is on a recently purchased 63 polara 500, pushbutton auto, AC. Previous owner did not drive it hardly at all the...