Search results for query: *

Does anyone know of a place that sells the lower, 8 prong headlight wire connector for 62-64 Plymouths? This is the plastic fitting that the front light wires snap into for connecting to the bulk head. Troubleshooting my gremlins I found this one crumbling apart and unusable.

I’ve had my battery neg disconnected for the past week while I installed a new dash. Today after getting done wiring up a new oil pressure gage and an oil pressure pressure sending unit for the idiot I reconnected the battery neg terminal and immediately went up in smoke. The hot wire from the...

What is this condenser looking thing next to the voltage reducer on this 63 Plymouth dash cluster. Don’t see one on my 62’ cluster?

What bulbs are correct for the dash cluster lights for 62-63 Plymouths. Are they 57s, 1893s or ??

I am Building a dash Cluster for a 62 Plymouth. I would like to significantly improve the background lighting. I understand that to change over to LED bulbs in need to change the voltage regulator to something lower than the stock one which I believe is 5 volts? Can anyone tell me what is needed...

Recently bought a replacement dash cluster for my 62 that has the clock. I have taken it all apart to begin restoring it and have a question on powering the clock. First does the clock run on straight 12volt? It doesn’t seem to get its power from the reduced voltage circuit board. It has a...

Recently bought a replacement dash cluster for my 62 that has the clock. I have taken it all apart to begin restoring it and have a question on powering the clock. First does the clock run on straight 12volt? It doesn’t seem to get its power from the reduced voltage circuit board. It has a...

While replacing bulbs in my dash the light socket for the low oil pressure light was missing so I found one and replaced it. Now my oil light is on - all the time… I have a mechanical gage and run around 50 psi all the time. I’m thinking PO pulled the bulb rather than figure out why it was on...

Opened my 63’ dash today to replace bulbs. Have a few questions. Will LED bulbs work in place of the T57s with the original dash resister? The bulb that’s currently used for illuminate the shift levers is a 363 which I believe are rated at 2.8 watt. Can I use a 893 bulb that is 4.6w to...

I’m sure this has been beat to death, but looking for opinions on the best plug to use in a stock built 361 / 4bbl with 727. I am reading that a J11 was the OEM but most references seem to indicate a 12 heat range these days. Since it’s not likely I’ll find J11s at the local parts stores is a...

Just a general question. I have a Red Top battery in my car with the AGM "technology" - basiclly saturated fiberglass. My charger and it has settings for standard, AGM and Deep Cycle and out of old habit I guess, I've just been leaving it on standard when I put the Red Top on the charger. Do you...

Spent the last two hours searching the net rying to find a chart that bridges the heat range from racing plugs to standard plugs ... no luck. Looking for some help!! I have tried running Champion C59YC, C61CX plugs in my car but need to go hotter. I have also run Autolite R3934 and 3935...