5.7 hemi's Recent Activity

  1. 5.7 hemi replied to the thread Front yoke into 833 tail shaft, need your opinion.

    No! It shouldn’t move 1 bit. Get a poly mount for it.

    May 5, 2021 at 5:09 PM
  2. 5.7 hemi replied to the thread Front yoke into 833 tail shaft, need your opinion.

    Trans mount?

    May 5, 2021 at 3:31 PM
  3. 5.7 hemi replied to the thread VOTE: Pin or Slider Disc Brakes?.

    The pin style can get stuck, the heads break off and it takes longer to change pads than the slider type. To each their own.

    May 5, 2021 at 1:35 PM
  4. 5.7 hemi replied to the thread Front yoke into 833 tail shaft, need your opinion.

    I don’t think so. I think you may have a problem with the ds, yoke, u-joints or tires.

    May 5, 2021 at 11:33 AM
  5. 5.7 hemi replied to the thread Front yoke into 833 tail shaft, need your opinion.

    Not concerned with the dust boot. Gotta push the yoke till it stops. Then pull out 3/4-1 inch. If your ds is short by 1/4 inch to...

    May 5, 2021 at 5:18 AM
  6. 5.7 hemi replied to the thread Sillynder Head Weights.

    How about 440Source heads?

    May 5, 2021 at 4:47 AM
  7. 5.7 hemi replied to the thread Front yoke into 833 tail shaft, need your opinion.

    If you bottom out the yoke onto the tail shaft then pull it out 3/4 to 1 inch, you’re set. That’s plenty of room to slip on the tail...

    May 5, 2021 at 4:46 AM
  8. 5.7 hemi replied to the thread How much time can one spend on hemi valve covers and tubes!.

    Those look like shit, send them to me and start over. LOL!Really nice job!!!

    May 4, 2021 at 6:51 PM
  9. 5.7 hemi replied to the thread Foil type Multi Layer Insulation in your home?.

    Most new homes are built with a foil layer on the bottom of the roofing plywood (osb). Mine has it, don’t know if it does anything....

    May 4, 2021 at 6:35 PM
  10. 5.7 hemi replied to the thread 62-65 vs. 6.4 Hemi Swap, Firewall Clearance, TTI.

    When I did mine, I could tighten the trans bolts to the back of the engine with ease and the passenger side head had decent clearance....

    May 4, 2021 at 11:23 AM
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.