Recent content by 66Belv74Dust

Looking for an Indy hemi tunnel ram to use for an EFI project. Doesn't need to have a top or be already setup for EFI. Let me know what you have.

For what im doing, the brackets don't worry me between 66 and 67 as ill probably make my own. Also not looking to do a full restore so turn signal holes aren't a big deal and may be better for additional lighting. Good information to know though as I did not realize this difference.

If you can send me some pictures of them that would be great. What size are they?

Looking for a set of 66-67 Belvedere Bumpers (Front and rear). Not looking for show quality pieces but also don't want completed rusted out bumpers as well. Located in Iowa (50703) so would probably prefer pickup due to cost to ship. -Zack

Looking for headers for Gen2 Hemi to fit in 66-67 b body. Not necessarily looking for brand new headers but let me know what you got and shipping to 50703 -Zack

Attached are some photos. All just set in there for mockup with jack holding up the rear but the mounts are mounted to stock v8 k frame as the car had a 318 Poly motor in it prior. I am waiting on the midplate to come as I plan to run one to hold the engine in place without a trans and I read...

I will try and post some pictures later as I need to get them off my phone but I am in process of putting a 5.7 hemi (possible twin turbo) in a 1966 Belvedere II. I have the engine sitting in the engine bay using the motor mounts from holley and I have to say it seems to fit well in there and a...

Looking for rear frames rails that fit a 66 Belvedere. Prefer entire rails but would do rail caps as well. Would need shipped to 50703 or within a couple hours could pick up.