66Satellite47's Recent Activity

  1. 66Satellite47 replied to the thread New electronic ignition 65 Coronet.

    jimbo, you do need to match the ballast resistor to the ECU and coil you have. Bypassing may work? The Mopar Perf/DC distributors were...

    May 18, 2022 at 6:19 AM
  2. 66Satellite47 replied to the thread Cam Degree Wheel.

    A real good vid, very complete about the process. He's got one FANCY degree wheel.

    May 18, 2022 at 5:41 AM
  3. 66Satellite47 replied to the thread Max tire size, I'm breaking my brain.

    I have found the specs on the Summit site to be right on. Going narrower on the recommended rim size does reduce the section width some....

    May 17, 2022 at 11:19 AM
  4. 66Satellite47 replied to the thread Cam Degree Wheel.

    Seems to me the Summit 11" wheel in post #2 is real good, I have a similar one from Jegs. You do need the dial indicator/magnetic base....

    May 17, 2022 at 7:44 AM
  5. 66Satellite47 replied to the thread Max tire size, I'm breaking my brain.

    If you have the ride height you want go with it. I agree with 33, the 16" tire selection is poor. Match the wheel width to tire size you...

    May 16, 2022 at 11:10 AM
  6. 66Satellite47 replied to the thread Air filter too small?.

    my apologies, missed the 1st few posts. Still hard to believe a 3" filter doesn't fit under the stock hood. But the solution is to put a...

    May 15, 2022 at 4:00 PM
  7. 66Satellite47 replied to the thread Air filter too small?.

    Get a drop base filter base housing, Then use the tallest filter that fits. You can pick from lots of filter heights if you look.

    May 15, 2022 at 2:23 PM
  8. 66Satellite47 replied to the thread Newbie to the group with a question about distributor pickups.

    The standard was a .007 brass gauge.

    May 15, 2022 at 7:13 AM
  9. 66Satellite47 replied to the thread WTB Edelbrock torker2 intake manifold for 440.

    That appears to be a 2nd gen Torker. Torker II was the next gen as I recall. All are real good manifolds. Although I was always a...

    May 14, 2022 at 3:58 PM
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.