Recent content by Cincy Kid

Stockton Wheel out of business..... | IH8MUD Forum

Here’s a couple of photo’s of each

I have 15” x 8” w/ 5” backspacing on my black steel wheels, & have over an inch to my leaf springs (275/60/15 tires). So I know the spacing will work, currently have 2 sets of wheels & the Magnum 500’s have 4-1/2” BS (275/60/15 tires won’t fit) Running 255/60/15 tires now. Want to put 275 width...

Does anyone know if you can purchase the Chrome Magnum 500 Wheels in a 15" x 8" with a 5" backspacing?

Does anyone know if you can buy the Magnum 500 Chrome Wheels in a 15 x 8 with a 5" backspacing?

My experience is the same, new sending unit, old gauge 5/8 when fuel & 1/2 tank when its on E, not a lot of confidence after the E reading. Wondered about leaving the original gauge intact & somehow putting on an after market fuel gauge, has anyone done this, or can it even be done?

Gear Vendors recommends a maximum of 5/8” play at the trans slip yoke

I had exactly the same issue, but, only after I installed the Gear Vendors O/D. The fix? (As long as your angles Trans/Driveshaft/Pinion are correct) Had to have another driveshaft made that allowed more yoke to grip on the spline. Call Gear Vendors & they will help you, mine was made...

Here’s my 67 GTX

Mark, Thx for the info! Scott

Frank, Thanks for the help! Scott

Frank, do you know of a wheel builder near me in the Cincinnati area? Scott

Frank, I have (15" x 8") black steel wheels, (1) has a 4-1/2" backspace, & the other 4-1/8". Can you grind off the welds, re-weld them so the back spacing is 4-3/4" for both rims? I am try to fit 275/60/15 tires on the back of my 67 Belvedere II. Looks as if they will rub the fender well & I...

Fran, Did it rub on the inside or fender?

Has anyone on this site put 275/60/15 (or wider) tires on 15" x 8" wheels on the back of a 67 Belvedere II?