Recent content by Damon

Pat, I have been looking after your build for almost 5 years now. In the meantime I completed my own build of a basket case 70 Satellite. Not only is your build a marvel in all ways, the information you shared helped me so much in reassembling my own car. Now if I could only get all that...

Been following this build for so long I am excited to see things coming down to the wire. :thumbsup: Curious what headlights and what HID kit was used? I tried some aftermarket lights and they didn't fit the chrome trim ring at all.

I am looking to use 3M Scotchlite to create a solid tail panel stripe with no logos. I wanted to see if anyone could provide me the specifications of the original decal including the tape width of the Middle stripe, tape width of the Upper/Lower Stripe and the factory correct gap between the...

Hey I would love to know more about this Wiring Kit. I have a 1970 Satellite and would like to use Hella H4, H1 combo for High/Low and High beam to replace the old sealed beams. I have read through the thread above and sorry for being a bit challenged :-) Outside the lights is this wiring all I...

Thanks for the picture.

Thanks. I was looking for the mounting on the inside of the fender. I should of be more specific. Gorgeous ride!

I should of been more specific. If anyone has a picture from inside the fender of the front markers installed I would be greatly appreciated. I am trying to determine the screw and nut combination and mounting to properly hold these.

Would anyone have a picture of the front marker installed?

Thank you very much @JimCoronette and @NJRR that was exactly what was exactly the information I was needing!

Looking for help on how front and rear side marker lights are installed on a 1970 b body. I didn't disassemble the car so I am at a loss here. I find the front lights may utilize a backing plate but I didn't find an equivalent for the rear. Would someone have any pictures or diagrams of the...

I ended up using a No 6, 6/32 pan head machine screw at 3/4 inch length. They lacked the cutting thread of the factory screws but worked just as well.

Does anybody know the correct material, number, length, and pitch for fastening the tail light lens to the housing? Thanks much =Damon

Damn that's pretty

Thank you. That's what I needed to know.

I am working on a 1970 satellite and would like to convert the tail lights to the GTX look. I see the tail lamp bezel and lens' are different but I can determine if the housing is compatible with the GTX bevel and lens. It appears the GTX lens mounts inside the housing versus flush on the...