• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Recent content by Dan mckillip

  1. Dan mckillip

    64 carter afb to edelbrock 1405

    Thanks Bob, yes, I'll likely be rebuilding the original carb after I get this car on the road & registered. It'll be a driver for my wife. since I'm a bit out of my comfort zone with carbs, i figured the straight line to getting this on the road was a new carb.. Thanks for the suggestion &...
  2. Dan mckillip

    64 carter afb to edelbrock 1405

    I I'm saving all original parts for the time being. Yes, its stamped with 3611S Thanks, Dan Mckillip
  3. Dan mckillip

    64 carter afb to edelbrock 1405

    Thanks, ill look into a conversion kit.
  4. Dan mckillip

    64 carter afb to edelbrock 1405

    64 dodge polara, 383 I'm replacing this carter afb with edelbrock 1405 carb. Whats this device on the pass side of carter carb? (Red arrow) It seems that the new carb covers this actuator. I haven't determined if the edelbrock needs this. Thanks
  5. Dan mckillip

    Help: need UCA torque specs

    Thanks for all the input, I really appreciate all. I originally, before I posted this question, set torque Wrench to 100 ft lb. And stripped the bolt threads. (wheel not loaded) Couldn't find a torque spec, so pulled stripped bolts out and installed the original bolts to 35 ft lb to be safe...
  6. Dan mckillip

    Help: need UCA torque specs

    I'm installing upper control arms on 64 polara, I can't seem to find torque specs on bolts attaching to body. Anyone help with this? Thanks!
  7. Dan mckillip

    64 polara floor pan cut with torch above trans? Can't be production, is it?

    Possible rework sealing evident on upper floor around shifter.
  8. Dan mckillip

    64 polara floor pan cut with torch above trans? Can't be production, is it?

    We should be headed back to Ontario in May, ... maybe, depending on covid.
  9. Dan mckillip

    64 polara floor pan cut with torch above trans? Can't be production, is it?

    Just pulled engine & trans, I noticed tunnel mods that look like they were performed with cutting torch. Could this have been done in Hamtramck? Or is it post assembly mod? Images taken from below shifter access hole. Thanks. Dan
  10. Dan mckillip

    Hello from New Mexico

    Were about 2-1/2 hours ~ south of Albuquerque.
Back
Top