diesel_lv's Recent Activity

  1. diesel_lv attached a file to the thread Heater control valve help.

    Got it out, had to disconnect a soft duct and a hard duct. Both fairly easy n then snake the sensor around the upper dash stuff and 3...

    20200602_162826.jpg Jun 2, 2020 at 7:28 PM
  2. diesel_lv replied to the thread Arizona Curfew.

    Not sure why it changed it to Polaris. I typed Monaco. Blues Brothers!!!

    Jun 2, 2020 at 5:05 PM
  3. diesel_lv replied to the thread Arizona Curfew.

    Is it a Monaco w a 440 police interceptor??

    Jun 2, 2020 at 9:59 AM
  4. diesel_lv replied to the thread Heater control valve help.

    Thank you. 110 here right now, I'll look at it in the morning when it's only 85-90.

    Jun 1, 2020 at 3:27 PM
  5. diesel_lv posted a new thread.

    Heater control valve help

    Ok, I did my due diligence and looked through the 218 posts that list heater control valve. 1967 Coronet w factory air. Leaking heater...

    Forum: Heating, Cooling & AC

    Jun 1, 2020 at 11:35 AM
  6. diesel_lv replied to the thread TTI 2.5" or 3" exhaust system?.

    I've got a '67 Coronet stroke 496 w TTI headers n 3" H pipe exhaust. I'm right at 600 hp. Super tight at gas tank. Rubber mallet work to...

    May 31, 2020 at 7:31 PM
  7. diesel_lv replied to the thread Great charging.

    Any pump with the anti cavitation plate on it or whatever each company wants to call it works.

    May 31, 2020 at 11:55 AM
  8. diesel_lv attached a file to the thread Great charging.

    I don't remember the cost offhand but it was very reasonable. Does not come with accessories, you source them used or order new ones...

    Screenshot_20200531-073830_Chrome.jpg May 31, 2020 at 9:40 AM
  9. diesel_lv attached a file to the thread Great charging.

    [ATTACH] [ATTACH]

    20200105_140227.jpg IMG_20140927_164101842 (1).jpg May 30, 2020 at 9:02 PM
  10. diesel_lv posted a new thread.

    Great charging

    I installed a SD Concepts Serpentine pulley setup on my '67 Coronet 4dr w 383 stroked to 496. The setup uses '95 era Duango alternator,...

    Forum: Electrical & Ignition

    May 30, 2020 at 10:00 AM
  11. diesel_lv replied to the thread True 12 volt source for Choke.

    The driver side of the white thing on the firewall that reduces voltage to the coil has true 12 all the time under cranking and run.

    May 29, 2020 at 11:03 PM
  12. diesel_lv replied to the thread Eddelbrock RPM.

    Ya, kinda figured that's what I'd have to do. I've already got a garage full of wall art. Radiators, fans, etc that wouldn't fit n they...

    May 29, 2020 at 9:18 PM
  13. diesel_lv replied to the thread Eddelbrock RPM.

    I know this is a little over a month old, got a '67 Coronet w 496 stroked 383, Edelbrock RPM with Fitech FI. Do you think hunt2elk's...

    May 29, 2020 at 8:00 PM
  14. diesel_lv replied to the thread Ford Contour electric fans.

    Not one with a diode. I text him and he said "if you are using the yellow wire, you need to use a 1/4 watt diode" did not say where it...

    May 29, 2020 at 2:55 PM
  15. diesel_lv replied to the thread Ford Contour electric fans.

    Ok, so when I turn my key to run, the fans come on low. While engine is cold. Fan controller company said I need a 1/4 watt diode as...

    May 29, 2020 at 12:04 PM
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.