Recent content by HemiMagnumRTAWD

I edited - was $500 in post title. I just want it gone

*Local pickup in Central Texas around Austin* 318 Short block. Air cleaner parts. Holley 4 barrel vacuum secondary. 318 Cylinder Heads. Miscellaneous muscle car odds and ends. Will not separate. Health forces sale. header bolt set and copper collector gaskets, fuel pump, voltage regulator, oil...

Due to health, I have been forced to sell my old cars. I was unable to complete my last project so I have a six pack I never installed. Three carbs, install kit, manifold and intake bolts and intake gaskets. No air cleaner. Not a T/A set up, it is from 2000's. Asking $2200 for the whole...

So I don't have the time or inclination to try and get some custom length pushrods, and plan on putting in inexpensive Summit 7.500 inchers. I wonder about the 7.8" that were in the engine and if they could have caused the camshafr and lifter damage shown in the photo. I plan on using a Lunati...

Thanks; I appreciate you taking the time!

Thanks for your input; I appreciate the help with this. This is just my third project and only the second deep engine dive. I am curious about the 200in/lbs specification. My Larry Shepard book says "...the shaft attaching bolts should be torqued to 30ft-lbs using the following order...

Thanks!

I bought a sweet 1966 Satellite with a '70s 360. it was a GTX clone half-heartedly done, or mostly unfinished. The 360 seems recently rebuilt. The block seems late but the heads look like non EGR; they have stout, maybe triple springs and the intake measured 2". These are not 340 or anything...

Digging in the ebook So my reading of the '66 Service Manual from the link above(THANKS!) shows a difference in adjustment for the 904(pg606 righthand column) and 727(pg606 lefthand column). There is an application chart(pg579) that shows the 904 only in sixes and 273s. I was always just...

From the library database 1965-66 Polara, Custom 880, Monaco w/Automatic Transmission & 1966 Coronet & Plymouth 318, 361, 383 Engines With Automatic, & Some 1965 Coronet & Plymouth 318, 361, 383 & 426 Engines With Automatic Apply thin film of multi-purpose grease on both ends of accelerator...

Any good source for downloadable service manuals on the web?

If anyone has the manual scanned for a 3 piece kickdown linkage adjustment please share. I pinned the upper pivot(on the intake) and pulled up on the trans rod and adjusted it to fit. My book then says unpin it, and to remove the return spring(did not specify carb or kick down) and push the...

Found! I got a '66 Satellite with a 360. Straight up project car. Dart will soon be "For Sale", that saddens me, I wish I could keep them all...

"crickets"

I am looking for an interesting car near Seattle. I was looking to spend no more than four thousand. I have a 68 Dart I am thinking of drag racing but want see if there is a b body close by to put my money into.