Recent content by plumkrazy

Is this resistor still available?

Thanks for the reply I’ll be emailing Rick

Thanks for the info and photos

Thanks for the info and photos

I am looking to install a trunk finish panel on my 68. Doe’s anyone know if there any drawings with measurements or screw hole locations?

I had new carpet installed drove car for two three weeks no problems came out one morning and would not start

I replaced the ignition switch and the key cylinder still has the same problem

I was thinking that but I replaced the distributor with a completely new one. it's possible the reluctor is defective?

Tried to fire up my 68 Satellite, 440, and it wouldn't start. The ballast resistor was extremely hot, replaced it and it started drove for about 3miles and it stalled, and it wouldn't start again just kept cranking. After about 10-15 minutes of sitting it started. drove her home and it stalled...

Thanks for the update and photo

Thank you

I know this is an old thread but I'm hoping someone can help. Is there a bracket that holds the jack in 68 convertible or does it just held in place under the spare tire ?

Thanks for the info

Thanks for the reply and photo

Thanks for the reply and tip