Recent content by ScottMH

Huh? No a 440

I have a 74 roadrunner I am thinking of turning into a drag car. How do they hook? Do I have to make some serious suspension mods to hook 500ish hp?

anyone know where i can buy a new center vent or have mine repaired 68 gtx

no one? :(

anyone know where i can eaither buy a replacement trim peice on the trunk for a 68 gtx? mine is badly corroded. if none are avaliable how about somewhere trust worthy enough to have it repaired and re-chromed. here is a picture of what im talking about

yes sir. i have all the ducts disconnecvted so im feeling the air as it comes out big rectangle hole out the front of the box.

i have a 68 gtx. i replaced every part in the a/c system. compressor (new sanden unit), condensor, evap, expansion valve, everything. i even had the heater valve in the box and the one on the firewall rebuilt. my pressures are dead on and my expansion valve is frosting. my driver side vents are...

my brake lights are acting funny. when i hold down the brake only the driver side works. if i turn the passenger side turn signal on with the brake still depressed once i turn the turn signal off only ther passenger side will light up. so it seems to follow the turn signals. operate drive side...

nothing huh?

hello. i have a 68 gtx with factory a/c that i am trying to repair. i do not have a wire going to the clutch on the compressor so i am trying to figure out which wire it is on the control head. all the wiring diagrams i have found do not have the a/c system in them.

if anyone has a wiring diagram of the a.c system that would be great

also, somewhere along the line the wire to my a/c clutch was cut and stuffed. so were does it orginate so i can run another wire.

Thank you! now do i need it for the a.c to work? because its clearly broken off the heater valve. also what is the proper heater hose routing?

no? well riddle me this. i am trying to remove the evap and it looks like the two drain lines have large disk soldered on it and is preventing it from being removed. what to do?

Hello everyone I am in the process of rebuilding my a/c box out of my 1968 GTX and I have a little doodad in there that im not sure what it is or if its needed or if i can get another one. here is a picture I assume its a temp. sensors to prevent ice over. but where did the end of the...