Recent content by skag101

It was giving me options. They would fit RB but not B. That's why I was asking what I had. I guess I'm the one that's not mechanically inclined. Haha.

Good deal. Are we talking stock manifolds? I have considered that as well. With it being a B block, the headers I was looking at will not fit anyway.

I'm looking at buying some blockhugger headers to replace the huge Hooker Headers that are on there now. Question is, they are asking if the engine is a Mopar big block "B" or "RB". Can someone tell me which I have? 1963 Sport Fury, 361 engine. I will probably have to cut the old ones out since...

Thanks for the reply. i wouldn't care to keep the headers if I can get the old starter out. I still haven't figured that out yet. I have it loose but no way to get it from behind the headers. It would be a lot of work to change everything out plus I do not have a garage to work in so...

Starter went out on my '63 Sport Fury so I get under to take it off only to find that it is caged in by the headers the previous owner installed. Absolutely no way to get it out unless removing the headers. So, I am in search of stock manifolds that will fit a 361 engine. I don't like the...

Well that didn't take long. Thought it may have been the resistor, which was broken, but the ignition wire going to the starter got against the headers and burned in half. At least it isn't serious. Replaced the resistor too. Thanks for reading.

Well, out for a spin for the first time this year. 1963 Sport Fury. Driving down the road and then nothing . Dead in the water. Pulled over and nothing. Wont turn over or anything. Been so long that I have worked on this car I'm not sure what to check first. It was running fine then just died...

Just realized what you said. I know nothing about the rear gear size. How do I find this out?

Thanks so much. I'll definitely give that a try. Where can you buy the gears at? Local auto store?

My 63 Fury came with 14 inch wheels and the previous owner installed disc brakes on the front and had to change over to 15 inch wheels. Of course my speedometer now it's not correct. Is there a gear I can buy to correct it or some other way to correct the problem? Any advice is truly...

The auto tranny in my '63 Fury doesnt seem to want to shift into the last gear. Goes from low to second but thats it. Is there something on the linkage I can adjust to comlpete the shifting? This has a floor shift for now until I can swap trannys back to push button. Tranny is a '65 model.

Well, the M/C does have two reservoirs. Discs on the front. It was bench bled and all bleeders are in top position.I have probably went through a gallon of fluid bleeding these. I've installed brakes for years so I've tried to do everything by the book. Never have I had a problem like this. I'm...

Well after several weeks of working on these brakes, all new parts, three master cylinders, I still have no brakes. They will pump up to about half pedal and hold. Then when I try again in just a few minutes it is all the way to the floor. I have no idea what to do next. Any suggestions?

After researching my current master cylinder, I found out that it has a 1-inch bore. Should this be sufficient or should I look for something larger?