Smokinnjokin's Recent Activity

  1. Smokinnjokin replied to the thread Header leak nightmare.

    UPDATE! The damn bellhousing dust/inspection cover got bent a tiny bit somehow and was flapping against the flexplate. Even staring...

    Apr 18, 2019 at 5:51 PM
  2. Smokinnjokin replied to the thread Header leak nightmare.

    Well, hold on to your butts. Its not a damn exhaust leak at all. Just went around with the stethescope and the sound was coming from the...

    Apr 18, 2019 at 5:15 PM
  3. Smokinnjokin replied to the thread Header leak nightmare.

    There is some tension on the headers from the exhaust system, not quite perfect alignment with the flanges and adapters and they don't...

    Apr 18, 2019 at 3:56 PM
  4. Smokinnjokin replied to the thread Header leak nightmare.

    I don't think they are the issue, but not 100% sure... i had some shitty tap jobs that were not perfectly matching the angle of the...

    Apr 18, 2019 at 1:55 PM
  5. Smokinnjokin replied to the thread Header leak nightmare.

    If i identify a spot thats leaking, is it ok to keep cranking down on the remflex gasket? Currently 20-25 ft-lbs, i got the impression...

    Apr 18, 2019 at 1:42 PM
  6. Smokinnjokin replied to the thread Header leak nightmare.

    Not sure... don't think so. Its a mid 70's smog motor with stock intake manifold and edelbrock performer carb.

    Apr 18, 2019 at 1:25 PM
  7. Smokinnjokin replied to the thread Header leak nightmare.

    Not my first b-body with headers, have put them on several (cheap shitty headers i might add, headman and cheapo summit!) small blocks...

    Apr 18, 2019 at 12:56 PM
  8. Smokinnjokin posted a new thread.

    Header leak nightmare

    Alright, so I am finally ready to sit back and ask the experts for help.I put some summit headers (g09040) on my '67 satellite with a...

    Forum: Mopar Exhaust Systems

    Apr 18, 2019 at 12:39 PM
  9. Smokinnjokin replied to the thread WTB 10" straight kickdown rod.

    Rick, yes I am still looking. It can be bent with a dogleg, straight, have a single bend, I can work with pretty much anything 10" long...

    Apr 18, 2019 at 12:29 PM
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.