Recent content by Svensson

OK. Story ends here. The Dart is ready and I use it here and there as a driver or just for fun at the drag strip. The Dart never won a race, but the people love to see it. Some pictures: It's a really nice driving car. And it is not slow at daily use. But...

Driver Side: And off to tech inspection and registration Done. Road worthy!

I went on with the right rear quarter. There was not too much metal left... AMD and parts from a lower quarter of a 1963 Fury. Doesn't fit too good. Please be patient with me. I did this the first time and without anything but a hammer, a...

so back on poor man's hydraulic lift left fender right fender right rocker rocker to panel right inner wheelhouse what's this in english? wheel opening? and in the middle of bodywork going to a drag race weekend the Dart did a 18.301 and we...

Now the engine runs fine and I could use the Dart as a daily driver for some days and a nice meeting here in Hamburg. But I knew there was much more welding to do stay tuned :icon_pidu:

The next ride to a nice meeting wasn't that good. The car went quite well, until it suddenly shut down and didn't start again. After we pulled the distributor, we knew what went wrong. At the qick rebuild of the 225, we changed the oilpump with another, that seemed to be in better...

great progress for me... did a little cleaning to the 904 and put it in alone. No problem with the 904. It is lightweight got me a B-body exhaust system from summit. The cheap one. After a little cutting and welding it went in. I had enough tubes to do a comlete system for a single...

Thank you! It is becoming a much more intensive project as I hoped. The engine didn't want to start today. Ok. Plan for the day was exhaust, which we did. compare:

Really love your progress, Marcel!!! See you soon. I think at the Herten event.

Last week we had a really great wrench’n’drink weekend. This was very cool and I wish to say thank you to all my friends who helped me with this. They all have great skills and they rock!!! cleaning the engine parts ready with the rear window ready with the first few beers...

go, Marcel, go !!! :icon_thumleft:

OK. Finally I could take the supporting frame off. And I think the floor looks really solid now Did some bodywork at the framerails.. ..and started working at the firewall. Too much air there. Parts from Marcel's Fury and a nice shot from my open-air-shop...

Finished the floorboards and patchwork at the framerails But there is still a little gap to close between the floor and the rusty firewall Next weekend should be end of metalwork. Looking forward to the enginework!

patching the driver side of the frame rail and a final look at the empty floor preparing the board and it is in. Beertime!!!

Got the Crossmember in. Next will be the floorboards. I did like mouses, but this is over now since they took so much of the structure off the car. Next will be the floorboards. That will be no big deal, I hope