Recent content by Vertex_Jeff

I have a QA1 Tubular K member in my '67 Barracuda that I drag race. I like it because it leaves plenty of room to install and remove my engine diaper. there is also a lot of room to drop the oil pan if needed. Weight savings was not a selling point for me. Just easier access and serviceability.

Looking for an Edelbrock CH28 intake for a 440 build. This is a low rise dual quad. Message me here if you have one you'd part with. I do not need carbs.

That color is beautiful and makes that body style look even cooler. What power train are you putting into that beast?

3.23 and a 2800 converter - just run it the way it is. I dont think it is worth changing up for a long highway trip. If you currently had 4.10's it might be worth putting in a different gear set for a trip, but not 3.23s.

Thank you for those pictures, man. This confirms that the brackets currently on y car have been butchered!

That's it! Thank you.

Guys, I appreciate the responses. The orange wire feeding it sure makes it look factory. It appears to have a screw hole for mounting it somewhere, and when that housing is grounded, the light comes on with the dash lights. I will poke around in the ash tray area.......

I was under the dash today in my '66 Belvedere wagon replacing some gauge cluster bulbs. While under there, I noticed this little light hanging down near the ignition key / ash tray area. It wasnt attached to anything, just hanging in the breeze. Anyone recognize what it is for? The length of...

This. Even my nice, Harland Sharp rockers (with needle bearings) have put wear marks onto the nice shafts they sell with the rockers. 2 seasons, maybe 50 or 60 1/4 mile passes, and about 2,000 street miles. I went bushed on my stroker build because of this.

I ordered a fiberglass rear bumper from Larry @ Sled City. He has made a couple, so he has a mold. Can anyone show me what the rear bumper brackets look like? I'm not sure what is on my car since a previous owner had installed a sedan rear bumper on it and flame-cut holes for the hinges.

Understood - sounds like they are similar to the Hookers in that price range then. Thank you.

I know this thread is over a year old now - but did you end up installing the Summit headers into your car? How much hammer work do they require?

I trust Cass / Dr. Diff 100%.

I just spent $10 a quart on some Valvoline VR1 at walmart. Also, $11 on a container of moist hand wipes for the racecar supply bin. EVERYTHING is over priced and has been since 2020. Then, to add insult to injury, I go through the self checkout and provide free labor for the store. I'm...

I will be there racing my '67 Barracuda.