Fan shroud

Moparsmitty · Feb 17, 2012

I've been looking for a fan shroud for my 64 Belvedere big block for a little while. It gets a little warm when I get in heavy traffic or sit at idle for very long. I'm at a good steady 185 when I'm flying down the road. I've looked at the stamped steel shrouds sold by Megaparts and a few other places and they look ok but seem a little pricey to me at $305 for the shroud and mounting kit. I don't remember a lot of the pre 66 B bodies having a factory shroud. Was it only on certain combinations? Any advice is appreciated.

Red63440 · Feb 17, 2012

I think most of the ones that had the shrouds were the A/C cars. There has been some conversation about the shrouds on early 90's Ranger trucks fitting but its not for sure.

Moparsmitty · Feb 20, 2012

Haven't heard about the possibility of a Ranger shroud fitting. Will see if I can find one in the yards around here and see if it will fit.

moparsteve636 · Feb 21, 2012

P.M. sent

Moose · Feb 21, 2012

Saw an article a few years back about making your own out of aluminum. Can you weld or have someone do it for you ? I think I have the mag somewhere !!

Andrew · Feb 23, 2012

Moose, If you have any more info on that, I'd love to see it. I'm in the same spot with my Coronet.

oldbee · Feb 25, 2012

Guys, used to run a 160deg. stat..worked pretty good. Hope this helps.

Fan shroud

Moparsmitty

Well-Known Member

Red63440

Well-Known Member

Moparsmitty

Well-Known Member

moparsteve636

Well-Known Member

Moose

Well-Known Member

Andrew

Well-Known Member

oldbee

Well-Known Member

Similar threads