Help removing tranny
- Thread starter Randy73
- Start date
Dako
Well-Known Member
Maybe the torque converter is sliding out of the trans and it's not completely separating from the flex plate?
Or, you may have it jacked up too high and the transmission housing is coming in contact with the transmission tunnel (floor pan of the car).
Or, you may have it jacked up too high and the transmission housing is coming in contact with the transmission tunnel (floor pan of the car).
roadrunnerman
Well-Known Member
maybe raise the back end of the car up and try to tilt the engine back to give you a little more working space.
racedodge
Well-Known Member
check to see if your oil pan is not resting on your k member
MoparBill
Well-Known Member
Did you remove the inspection cover on the front, and 4 torque convertor bolts? If so, use a small prybar to separate the convertor from the flexplate. Like said above- be sure the trans crossmember is unbolted and lowered so the trans doesn't hit the firewall.
Pugly
Well-Known Member
If you got it 2" from the block, I think the transmission jack would probably be the thing holding it up. 2" from the block should be a straight drop down.
Similar threads
