no462of12K
Well-Known Member
need help/info from any one that has went from points(mallory yl) to electronic ignition--67 440 motor--any help sugg. appr.
point got to go
- Thread starter no462of12K
- Start date
WP29440SE
Well-Known Member
RustyRatRod
Well-Known Member
I really like the Mopar stuff too. I see MSD this and MSD that all the time, but that Mopar conversion is hard to beat IMHO.
Hemi Rebel
Well-Known Member
- Local time
- 3:36 PM
- Joined
- Apr 22, 2012
- Messages
- 4,170
- Reaction score
- 1,918
- Location
- Where the outlaws live
Geez 225? Been a while since i had to buy one. I think I paid 125 last time. That was a while ago obviously. They are a breeze to install and worth every penny. The only drawback to the factory dizzy is fine tuning the advance curves is a bit of a pain since they are deep inside the thing.
MoparMitch
Well-Known Member
- Local time
- 3:36 PM
- Joined
- Apr 12, 2011
- Messages
- 3,818
- Reaction score
- 2,865
- Location
- Friendship, Maryland
Pertronics works great if you want to keep your original looking distributor. Other than that Mopar Performance is the way.
Dako
Well-Known Member
If cost is your driver, look at the 'Skip White' distributor ($54!). http://www.skipwhiteperformance.com/listview.aspx?Product=A&Sub=C It is a self contained electronic setup. Its noticable difference is that it runs a newer cap (male ends...Leave the 'keeper hat' off the wires and you don't notice the difference.) and has a small square box on the side. Drops right in. Only 'mod' to make it work is to to bypass the balast resister (connect wires with a pigtail) or do like I did and remove the reo-stat from the back of balast and solder in a piece of 18gauge wire. Leave it in place to look original.
Nacho-RT74
Well-Known Member
My votes are for... Rev-N-Nator 
, which is the same Mopar Configuration
, which is the same Mopar ConfigurationSimilar threads
