• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

What did you do to your Mopar today?

I had fun with grinding down some welds ive let get ahead of me! Always fun stuff :)
 
Installed 4 new KYB gas adjust shocks on my RR, $118 shipped from Rock Auto. What a huge improvement, next up dropping the front down an inch and getting an alignment.
 
I repainted my master cyl lid today. I painted it with stainless steel paint. And used some detailer on the trunk. Thats about it as my knees were already killing me when I started so I had a Budwieser while I worked. Ron

409849854.jpg
 
Got some fabbed brkts powder-coated, got the longer wheel studs for the front, and my front tires arrived. I'll have them mounted and ready tomorrow.
 
A week or so ago I picked up a little 1988 short box. :hello2: Hey, it's a Mopar! It's a V6 auto. I'm gonna use it as a driver and maaaayyybe later put a 440 in it! It's in pretty good shape and I have replacement fenders and doors for it as the passenger side has a little rust. Anyway today I put some "Dynomat type" sound deaden-er in it.

IMG_1322.jpg

IMG_1323.jpg

IMG_1352.jpg

IMG_1353.jpg
 
Finished up the metal work on the windshield cowl today. image.jpgimage.jpgimage.jpg
 
My RR's buried behind a smashed up bus in the shop.

I leave for NY in a few days and won't be back until next year, so I poured a bottle of Stab-Bil in the tank and let her run for about 10 minutes before covering her up
 
Over the weekend re installed bumpers,,,that came back from re chrome :)
Also painted the drums blue,,,I'm not sure I like it yet,,but gonna give it some time,,see if it grows on me20141009_181831_resized.jpg20141011_132343_resized.jpg20141011_132458_resized.jpg20141011_132516_resized.jpg
 
Wired the tach I mounted 3 months ago. If I had known it would only take as long as it did, I would have done it 3 months ago!
 
image.jpg Welded in the driver's side floor panel.
 
Repaired the old spring perches on the 67 and fabricated a new rear crossmember assembly.

IMPG1595_zpsec3f2a19.jpg
 
image.jpgimage.jpgimage.jpg Built the left side frame connector and welded it into place. One down, one to go.
 
Auto Transport Service
Back
Top