• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

SOLD Drive Shaft 50 3/4 inches Center to Center

Status
Not open for further replies.

65GT

Member
Local time
8:38 PM
Joined
Mar 13, 2016
Messages
15
Reaction score
0
Location
Kingston, Ontario
Feedback: 0 / 0 / 0
Looking for a driveshaft 50 3/4 inches yoke center to center. Apparantly this is the approx length as the shafts in 1966-1973 Belvedere Coronet Satellite Road Runner GTX with 383,400,426,440 motors. Rear end is an 8 3/4 and the tranny is a 727.
 
I looked for over a year and all I found was Junk. Finally bit the bullet and had one made. It gives me more piece of mind when I am out romping on it. Good luck with your search.
 
I looked for over a year and all I found was Junk. Finally bit the bullet and had one made. It gives me more piece of mind when I am out romping on it. Good luck with your search.
Yes, I hear you there, I'm already to go that route to, even if I had a longer one the cost is still around 260 plus to shorten/balance,,certainly can't wait all summer... that would be stupid, lol
 
Yeah, mine came with good joints, yoke, epoy paint and ballance of course.A touch over $400 and local support if any issues. I think Inland Empire quoted me 5 bills plus shipping. YIKES!!
 
Well I finally pulled the driveshaft out of my 68 Coronet. Mine is definitely longer from center to center it is 56".
Here is a a pic that helps describe my driveshaft. This is an OEM part original to the car.
Good luck on your search.

29kuosi.jpg
 
Got on . 150
This is OEM unit no junk
Send your e address
How do I empty my pm box?
 
Got on . 150
This is OEM unit no junk
Send your e address
How do I empty my pm box?
Go to conversations, once you see them all there is a small tick box on left side, check the ones you don't want and then click leave conversation. Each one will free up more space.
 
Well I finally pulled the driveshaft out of my 68 Coronet. Mine is definitely longer from center to center it is 56".
Here is a a pic that helps describe my driveshaft. This is an OEM part original to the car.
Good luck on your search.

29kuosi.jpg
Thanks for the info!
 
Status
Not open for further replies.
Auto Transport Service
Back
Top