• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

62 Plymouth brake lines

peakandscoot

Well-Known Member
Local time
3:09 AM
Joined
Nov 12, 2015
Messages
228
Reaction score
158
Location
Clearwater FL
All my brake line were striped by my uncle before i got the car. I believe i am missing some sort of bracket but dont know. Can anyone post a picture of where the rubber line that comes out off the axel block on one end then connects to the hard line going forward. I am guessing there should be some sort of bracket where those to lines connect. I am posting a picture of the spot i think it should bolt up to. It is a shot from behind the axel looking forward it also shows the axel vent bolt for a frame of reference. Am i correct and can anyone post a picture. I have lots of parts and my actually have it if i knew what i was
20180214_100218.jpg
what i was looking for or will fabricate something.
 
All my brake line were striped by my uncle before i got the car. I believe i am missing some sort of bracket but dont know. Can anyone post a picture of where the rubber line that comes out off the axel block on one end then connects to the hard line going forward. I am guessing there should be some sort of bracket where those to lines connect. I am posting a picture of the spot i think it should bolt up to. It is a shot from behind the axel looking forward it also shows the axel vent bolt for a frame of reference. Am i correct and can anyone post a picture. I have lots of parts and my actually have it if i knew what i was View attachment 571532 what i was looking for or will fabricate something.


Hope this helps !

Picture 167.jpg
Picture 134.jpg
 
i dont know of any place that has a place for a 4 bolt bracket something is different

The four bolt bracket is to match the original that was originally welded to the floor pan.
 
The four bolt bracket is to match the original that was originally welded to the floor pan.

I was thinking just that. I wonder if they were known to pop off. Like I stated, there's one exactly like it on my passenger side. Has a plate on the inside of the car with sealer in between.
 
I was thinking just that. I wonder if they were known to pop off. Like I stated, there's one exactly like it on my passenger side. Has a plate on the inside of the car with sealer in between.


Car was originally a /6,made them out stainless and replaced both when I installed the 3" TTI system.

Picture 158.jpg
 
FYI, when you install the brake hose, do it with the rear housing all the way down at full extension. My new hose was just a tick short and I had to do some tweaking on the bracket so there wasn't any strain on the hose.
 
Auto Transport Service
Back
Top