MARTY JONES
Active Member
restoring 64 polara 500, i have original bucket seat,slider,floor mount installed, no headliner and my head hits the roof. has anyone lowered seat ,if so how?
more head room
- Thread starter MARTY JONES
- Start date
Cncguy1
Well-Known Member
If the seat reclines you may have to go that route. You could buy a low profile racing seat.
The thought keeps crossing my mind to sink the floor pan a few inches around the seat perimeter, but again wouldn't be factory correct.
The thought keeps crossing my mind to sink the floor pan a few inches around the seat perimeter, but again wouldn't be factory correct.
MARTY JONES
Active Member
trying to stay original,will look at hinge,may be able to change stops.
miller
Well-Known Member
Assuming you already have the seat mount brackets adjusted all the way back in the slots? Farther back, and lowers.
Cncguy1
Well-Known Member
Also if your seats have been reupholstered maybe check and see if they used to much padding.
MARTY JONES
Active Member
yes i do,must have been much smaller men back in the day
MARTY JONES
Active Member
not reupholstered yet,may see if he can put a little less padding in
YY1
Well-Known Member
Not sure about 62-65, but 66 and up have 3/8" thick by about 2" round spacers spring clipped to the studs that go through the floor.
I have a long spine, so that's the first mod I do to any new acquisition...
...usually on day #1. Get those suckers outta there.
1966 only (AFAIK) bucket seat tracks are adjustable for height.
There is about 1.5 inches of adjustment.
You might try to locate a set of those. Maybe '65 is that way too.
Never seen any up close.
I have a long spine, so that's the first mod I do to any new acquisition...
...usually on day #1. Get those suckers outta there.
1966 only (AFAIK) bucket seat tracks are adjustable for height.
There is about 1.5 inches of adjustment.
You might try to locate a set of those. Maybe '65 is that way too.
Never seen any up close.
lewtot184
Well-Known Member
look for adjustment at the seat brackets. I have a 65 bench seat and I've fought head and leg room and i'm only 5' 9".
YY1
Well-Known Member
Looks like the bench brackets might be adjustable as well.
...and look at the drawing of the bench seat.
it's a pre-64 split back height model.
That suggests the early seat tracks might be adjustable too.
...and look at the drawing of the bench seat.
it's a pre-64 split back height model.
That suggests the early seat tracks might be adjustable too.
MARTY JONES
Active Member
yep all the way back and all the way down.
miller
Well-Known Member
Don't know if it's an option you would want to do. You'd also have to see how much room you have to work with.
Bottom halves of the mounts, cut more of the slots, to lower the seats.
Bottom halves of the mounts, cut more of the slots, to lower the seats.
- Local time
- 2:37 AM
- Joined
- Feb 20, 2012
- Messages
- 59,186
- Reaction score
- 204,539
- Location
- Maskachusetts
I've heard that installing tilt wheel gives more head room.
Similar threads
