Clutch fork return spring

69tri · May 13, 2018

Where does the clutch fork return spring attach? I know one end hooks on the fork. I don't see a hole for it. Does it just clip on it? Plus I see nowhere to connect it on the other end. Am I missing a bracket? Doing a 4 speed swap so I have never seen the setup on one of these cars before. This car is turning out to be a battle.

65Fury440 · May 13, 2018

http://www.drivinithome.com/mopar-clutch-linkage/
Does this help?

dadsbee · May 13, 2018

There is a notch on the fork for the spring to locate in. The other end goes to the bell housing, although mine (shown) is a scattershield so I just use the extra starter bolt hole. That is also an A body adjuster rod on mine, long story. but been there since 1979.

radical rob · May 13, 2018

on a regular bell housing there is a small hole near the edge for it to hook to. can be a pain to get it pulled back and into the hole.

69tri · May 13, 2018

I can't seem to find the hole for the spring. Isn't it on the edge of the bell housing? I hooked it in a small gap where the starter mounts. If anyone has a picture of the bell housing out of the car with location that would be super. This car is fighting me one thing after another.

Richard Cranium · May 16, 2018

69tri said:
I can't seem to find the hole

Too much hair?

Clutch fork return spring

69tri

Active Member

65Fury440

Well-Known Member

dadsbee

FBBO Gold Member

radical rob

Well-Known Member

69tri

Active Member

Richard Cranium

FBBO Gold Member

Similar threads