• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

WTB need rear quarter trim for 70 sat 4 door

Status
Not open for further replies.

jprather

FBBO Gold Member
FBBO Gold Member
Local time
3:55 AM
Joined
Dec 30, 2014
Messages
1,659
Reaction score
1,862
Location
Tennessee
Feedback: 3 / 0 / 0
looking for rear quarter trim for rear quarter( right side ) for a 4 door 70 satellite and right side rear wheel opening trim
 
Last edited:
Can you measure the side you do have and tell us how long the piece is?
I have parted a couple of wrecked 1970 Satellite's and have some pieces.
 
waiting on my friend to get measurements ( it's his car ) just helping him out
 
trim is 58.5 inches long
 
Thanks for the measurement!
I have checked my 1970 Satellite trim and have 2 pieces 50 1/2" ( 2 doors ) and 2 pieces 59" ( front fenders ).
The front fender Chrome is tapered down at one end so you can't trim it and use it for the quarter.
SORRY!
When I did some checking on the taper I realized that the side moldings I have are for 1968 and 1969 Satellites. They are not the wider parts with the black section in the middle!
Double sorry!
I am going to clean them up and list them in the for sale section soon!
 
Last edited:
How long is the taper?

I made trunk lid trim for my 66 Coronet from 66 Charger fender trim.

The profile is almost the same, and I cut it to length, but left the "top" of the channel long, then trimmed it to match the profile, and bent it over on the ends.

You can't tell unless you get right up on it.

My plan was to flow solder into the small gap but it turned out so good I haven't bothered.
 
Good question YY, he lives local, maybe we can all meet up and you can look at what he needs, or.. if your in the mood head over to Lakeland Cruizers show at Big Lots on S. Fl ave friday
 
The car is filthy-

IMG_20181202_143816.jpg


Might be an option if a 4D part can't be located.
 
this is what it looks like

20181130_143904_1543606795679.jpeg
 
Might be a little tougher to do my trick on that profile.

Probably saw through that ridge in the middle so it could bend over.

..but then the end would have the ridge.

Hmmm
 
Status
Not open for further replies.
Auto Transport Service
Back
Top