EngineerDoug
Well-Known Member
Hello all, I have a question about headlamp bezels and how they install on a '68 Coronet. I See that the outboard headlamps sit a bit deeper in the fender than the inboard ones do - by perhaps 1/2" or so.
I have a hardware kit that includes the round plastic standoffs that snap into the headlamp mounting area of the fender. The headlamp bezels (not the rings, but the outer sections of the grill) screw into these four standoffs. These standoffs are, however, all the same length = 1.25". Shouldn't I have two long ones and two short ones per side?
Mebbe I need to shorten two standoffs and use them in the inboard positions; I dunno. Your advice is appreciated; thanks.
I have a hardware kit that includes the round plastic standoffs that snap into the headlamp mounting area of the fender. The headlamp bezels (not the rings, but the outer sections of the grill) screw into these four standoffs. These standoffs are, however, all the same length = 1.25". Shouldn't I have two long ones and two short ones per side?
Mebbe I need to shorten two standoffs and use them in the inboard positions; I dunno. Your advice is appreciated; thanks.