YY1
Well-Known Member
So, apparently there are not any dimples for the screws that hold these to the floor.
I see dimples for a slap-stick bracket, but if I try to use those, the pod is WAY over to the pass side and not level.
The carpet I was installing at the same time had been cut for a shifter, so I ended up mounting the pod so it would cover most of the hole. It also put it in a decent position for my arm and the radio controls.
I'd just like to know where they're supposed to go from the factory.
I see dimples for a slap-stick bracket, but if I try to use those, the pod is WAY over to the pass side and not level.
The carpet I was installing at the same time had been cut for a shifter, so I ended up mounting the pod so it would cover most of the hole. It also put it in a decent position for my arm and the radio controls.
I'd just like to know where they're supposed to go from the factory.