440ronnie67
Well-Known Member
Last edited:
I need to weld the round stock that keeps pressure on the leafsprings because it was too wide where the clips hold it in.
Found a pic of my radiator mod.View attachment 786189 View attachment 786189 Have the inboard leafsprings installed, with caltracks. I need to weld the round stock that keeps pressure on the leafsprings because it was too wide where the clips hold it in. Have not adjusted the pinion angle because my motor and transmission are out. I also moved the radiator and fans about 3 inches forward toward the front bumper for more room.
Oh, that's a great idea! ThanksBefore I mounted my spring boxes I drilled another set of holes 1" towards the rear to address this tall tire issue. I think a driveshaft slip yoke can handle a 1" difference should the need arise.
How does that effect the rear spring mount?
That's what I haveYou take the spring apart - in my case Caltrac mono leafs - and you move the locator pin.