• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

EFI

The mock up, this is going to take a lot of finesse just to bolt this up,raised port heads would be much better, but I will figure it out.
efi21.jpg
View attachment 792673 View attachment 792674
 
Thanks guys, I had to think this one out, the throttle cable & transmission throttle pressure control cable, air filters, the ram tubes will be silver when done., will paint my brackets black.
I have surgery tomorrow so progress will stop for awhile.
efi26.jpg
View attachment 794211 View attachment 794212
 
I sell tennis balls in packs of 7 if you need them.
 
Don't work on the Charger after surgery they said, I can't help it lol, injectors are now bolted on & starting to wire it all up.
efi30.jpg
 
Last edited:
Here is a setup on a buddies car. Old School Hilborns.

The other picture is the motor out of my funny car back in 1967 with Hilborns which I ran on 70% Nitromethane and 30% alcohol.

084.jpg 20110624_29.jpg
 
Tuning is going ok, the Holley HP is really not the correct choice for a Hilborn set up even though that is what they sell with the injector assy, it only has 1 o2 sensor to tune the ECU, it really should have at LEAST a bank one & bank two base fuel map that the ecu runs on. when the engine heats up all those throttle blades move & changes the calibration, I hooked up my Innovate wideband through a channel on the Holley ecu so I can at least datalog both o2's side by side & can manually tune the right bank to match the left bank Holley ECU wideband. wide open throttle is not a problem, its all the very light throttle low rpm areas that are tough to tune with 8 throttles & one o2 LOL. it idles like a stock cam 440 hp, can run 1500 rpms in overdrive & lock up the converter,,,, smooth as glass. the Dominator Holley ECU has two o2 sensors but you can only pick left or right or average of the 2 sensors for the ECU to tune off of.
The but dyno says its pulling MUCH harder, even in the 100deg heat, my converter used to flash about 4200, now you nail it & its 5000. I hope the trans & or the converter are ok
smile.gif
it does not feel like its slipping it just PULLS
Doing some Data logging, its only 103deg, Love my A/C

 
been cutting on hood, not exactly what I want but no choice for now.
efi40.jpg
efi38.jpg efi42.jpg
 
You must log in or register to reply here.

Similar threads

D
383 EFI intake
Replies
16
Views
642
Budnicks
Budnicks
davek
WTB 1970 charger drivers side fender
Replies
7
Views
529
tommygun
tommygun
Marson
WTB A12 Base Plate Fiberglass
Replies
2
Views
265
Marson
Marson
2quick
Got the 572 back, Now lets find some power
2 3
Replies
44
Views
3K
2quick
2quick
62maxx
  • Locked
FOR SALE NOS (73-74?) Charger SE sail panel emblems & 73-74 Sebring emblems for sale
Replies
0
Views
343
62maxx
62maxx
Auto Transport Service
Back
Top