ThanksI suppose you could IF you can drop the transmission out with the header in place.
Mike
Thanks everyone. I have done this before, just not on this car. I have 4 post drive on and trany jack. The headers are Tti 2 inch step. Just thought I would ask and see if anybody had tried. Thanks againI couldn't move the trans back without loosening at least one header. The headers were just too tight to the bell housing.
You need to remove the trans with the torque converter still in the trans. Remove the converter, then replace the seal, then reinstall the converter making sure the pump dogs are engaged. Doing this with the car on jack stands will be tight but not impossible.
Thanks I'm going to try to drop it out without loosening the header. The car came with Mopar stage 6 heads so the bolts go into the water jacket (Not my choice for heads) but seem to work ok for this combo.with my hooker i had to remove 1 header with my tti headers i can drop trans with out touching the headers.
great point i also run the stage 6 mopar i think your good . also get a starter for a magnum 360 and install it it will come out with the header in . did it a long time ago so dont remember out the top or bottom. rout your wiring to the rear of the engine block use a wire loom on trans bolt then up and across firewall.Thanks I'm going to try to drop it out without loosening the header. The car came with Mopar stage 6 heads so the bolts go into the water jacket (Not my choice for heads) but seem to work OK for this combo.
Thanks I have already replaced it twice with rebuilt mini starters. First one lasted about 2 months . Had to loosen the header to remove and replace both times.great point i also run the stage 6 mopar i think your good . also get a starter for a magnum 360 and install it it will come out with the header in . did it a long time ago so dont remember out the top or bottom. rout your wiring to the rear of the engine block use a wire loom on trans bolt then up and across firewall.
have made a shield to go between the starter and the header ?Thanks I have already replaced it twice with rebuilt mini starters. First one lasted about 2 months . Had to loosen the header to remove and replace both times.
Thanks for idea and no shield as yet. I think the first starter was just a bad rebuild.have made a shield to go between the starter and the header ?
Pics of the heat shield. Great ideahave made a shield to go between the starter and the header ?
i have not made mine yet but i will . im sure others hear have .maybe a new thread to be started ?Pics of the heat shield. Great idea