Moparnocar
Well-Known Member
I know, non Mopar ( that's probably the problem) but this could help diagnose Mopar disc brakes, and this is the only car site I'm on, so my apologies
2002 Acura TL type S brakes new all around. On the first test drive, real bad grinding from driver front. Got worse turning left
Found the outer edge about 2 inches in on the outerside of the rotor, had heavy wear, just 3 miles
Replaced pads, thinking poss defective pad, see problem
Replaced rotor, caliper , and pads. Not as bad, but still noisey and most wear on the outside pad and rotor surface.
Bearing was recently replaced by some one else, with new hub. I made sure rotor sits square as I tightened the wheel. No wear on the bracket from rubbing on rotor, and bracket was replaced.
These photos are 3 miles, new rotor, pads, caliper and bracket
What am I missing??? I'm stumped
2002 Acura TL type S brakes new all around. On the first test drive, real bad grinding from driver front. Got worse turning left
Found the outer edge about 2 inches in on the outerside of the rotor, had heavy wear, just 3 miles
Replaced pads, thinking poss defective pad, see problem
Replaced rotor, caliper , and pads. Not as bad, but still noisey and most wear on the outside pad and rotor surface.
Bearing was recently replaced by some one else, with new hub. I made sure rotor sits square as I tightened the wheel. No wear on the bracket from rubbing on rotor, and bracket was replaced.
These photos are 3 miles, new rotor, pads, caliper and bracket
What am I missing??? I'm stumped