Seat belt holes for 3 point harness.

Okay, due to my ignorance of getting ahead of myself, I have put sound barrier all over the floor of my 69 Coronet hardtop and not marked the holes to bolt up a three point harness. Tried to find by poking with "sharp stick " but doing nothing but making holes in insulation. According to what I have been told, my car should have nuts built into the inner floor pan somewhere below the wiring harness trough. These would be adjacent to the seat belt harness holes located on the roof line. I have poked around and felt as much as possible and can't locate. Either I am mislead about holes being there or I am in the wrong place. I could sure use a measurement from edge of door frame back and distance off floor or the inverse, distance from edge of wiring harness tray down to help locate them. Please correct me if I am wrong about pre drilled and tapped holes for a three point harness! Thanks fellow FBBO members/ Gurus!

As Gilda Ratner used to say....."Neveeer Mind". I was waaay too far back in my probing. I found the holes 8" in front of door frame, which seems like a pain in the butt for anybody trying to get in the back seats! I was poking 3-5" behind door frame...to the rear of car looking for the holes, anyway, sorry about the post.

and where are the upper points? a location in reference to quarter glass would help

Lngbrdz said:

and where are the upper points? a location in reference to quarter glass would help

Click to expand...

Hope this helps....Jim

69B7RR said:

View attachment 969854
Hope this helps....Jim

Click to expand...

I think it does thank you