Montclaire
Well-Known Member
Contact seller
73 Satellite sedan rolling shell. Was a Texas car, now in Pennsylvania. Front floor pan and rear seat pan are same as coupe - not reproduced! Same with inner wheel tubs and front subframe. Middle floor pans are longer but could be trimmed to fit coupe. Cowl sheetmetal is the same (but A-pillars are not). Many other small pieces that probably interchange. Was an AC car so it has the 26” radiator support. Pass quarter was sold, drivers still solid. B-pillars already removed.
Drivers side inner fender is rotted in the battery area, trunk floor is rotted, rear rails aren’t bad but don’t fit coupe - may be good for blow out patches.
Has a complete 73 column with keys so it will steer, complete 8.25 rear and front brake/suspension setup. On 14” cop wheels so it will roll right into your trailer. Asking $850 but feel free to make an offer. If it doesn’t sell I’ll finish cutting it up myself. Lots of good metal for your 73/74 b-body project, either as full panels or patches for pieces that will probably never be reproduced. Located near Scranton, PA. Bill of sale only if needed, no title and no numbers. Thanks
Drivers side inner fender is rotted in the battery area, trunk floor is rotted, rear rails aren’t bad but don’t fit coupe - may be good for blow out patches.
Has a complete 73 column with keys so it will steer, complete 8.25 rear and front brake/suspension setup. On 14” cop wheels so it will roll right into your trailer. Asking $850 but feel free to make an offer. If it doesn’t sell I’ll finish cutting it up myself. Lots of good metal for your 73/74 b-body project, either as full panels or patches for pieces that will probably never be reproduced. Located near Scranton, PA. Bill of sale only if needed, no title and no numbers. Thanks
Last edited: