• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Can 66 Sat top of fender trim split be aluminum welded?

I'd be interested if it works on 55 year old aluminum.
I'm a skeptic but who knows? Worth a try
 
I’ve seen that demonstrated at gun shows too - although it’s been awhile. I might try to track it down and try it on a piece of scrap aluminum trim I have.

After doing a little research it appears these low temp aluminum repair rods have a high zinc content and probably would not take well to re-anodizing where exposed. Decided to not go down that path for right now.
 
Last edited:
Dang - looking at the other side and it’s split right at the turn signal light too - just like the other side . The splits are so tight you can feel them more than see them. I may just carefully remove them and apply JB Weld to the back side to hold the tightly together.
 
Should check if there's a why they split. A little fiberglass to reinforce the JB?
 
So, you need both fender mldgs ? I can ask the man who I bought my car from and see if he has any spares

Im looking for an NOS pass door mldg if you hear of one.
 
I would appreciate your asking. I have a bunch of various trim up in the attic left over from my 67 GTX scrounging junkyards days. Probably a lot of other owners do to.
 
I would appreciate your asking. I have a bunch of various trim up in the attic left over from my 67 GTX scrounging junkyards days. Probably a lot of other owners do to.

I just put a call into him to see if he has anything. When he did my car he used all NOS except for the pass side door. that one he had to use a REALLY nice used due to unable to find an nos one
Should here back next day or 2
 
PM sent with contact info/
he said he thinks he has them

Bill
 
Auto Transport Service
Back
Top