• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

What did you do to your Mopar today?

Got my shocks installed today plus my radiator.
E0E93030-6F75-45DC-958D-7F0FCC1263D3.jpeg
D7A07901-63E4-4570-826A-8EE19CD88243.jpeg
 
Embarked on my rear window today. Its worse than i expected, but much better than many I have seen.

PXL_20210130_230809244.jpg
PXL_20210130_230702960.jpg
PXL_20210130_230643777.jpg
 
installed a Tanksinc Metermatch box between my fuel sender n gas gauge...did the calibration and went for a drive...added gas...level matches up with amount of gas finally.....hit 500 miles on the new SST TKO500...break in period over...time for a fluid replacement

saw a pretty sweet race car out on road too


watermelon

C71ABF8B-1B4F-443D-BAD7-A014AF3D8007.jpeg 2128B9A5-AA1B-4B8E-927E-BE0A02C00C8B.png EB9F26B0-2EB5-4FB3-9BF1-91413BA24F53.png 424E0EEA-BEDB-4549-A194-CCE5CA160F6B.jpeg
 
Got the body epoxy primed this morning after prepping it this past week. Now the primed body panels can go back on and I can start the body work!

2021-01-30_10-21-07.jpg
2021-01-30_10-21-28.jpg
2021-01-30_10-21-48.jpg
2021-01-30_10-22-04.jpg
 
My Charger has a fibreglass hood. The bolt that holds the inner side of the right headlight assembly was missing because it wouldn’t let the hood down low enough to get the hood pin in. I drilled a hole to allow for the bolt head and touched a little paint on it to make it looked finished. I did both sides so it looks like they’re supposed to be there.

F3AE7AB3-77A8-4822-9F62-AE65A19C16C9.jpeg 7C9BF462-EB67-433E-AA25-02365343BABC.jpeg
 
striped drivers side door got lucky again one small dent and no rust
 
Auto Transport Service
Back
Top