• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Engine wiring harness connector to bulkhead fitting

F

Frankb

Well-Known Member
Local time
2:08 PM
Joined
Jul 14, 2012
Messages
228
Reaction score
92
Location
Tucson
I need to replace the plastic terminal connector for engine wiring harness in 68 Charger. I have a new plastic connector. On the old connector there's a gasket of some sort that goes inside the connector and wraps around all the terminals. The new connector does not have this. The gasket has 8 slots where it would slide over the 8 male terminals. Is this an issue?

connector1.jpg
 
I would say yes. .i think the foam gasket also helps secure the connection by adding a little back pressure after they are connected. I got all my new plug gaskets from Evans wiring
 
Thanks for the info. I was thinking pump some grease in there but not any more. Order me some gaskets tomorrow.
Frank
 
You must log in or register to reply here.

Similar threads

Charger Fan
Bulkhead connector terminal size
Replies
7
Views
865
69_Coronet
6
Stumper
Bulkhead wire connector
Replies
2
Views
624
Stumper
Stumper
ChargerPilot
Source for electroluminescence dash wiring connector?
Replies
4
Views
815
Dean Prevolos
Dean Prevolos
Tony 69
Low voltage to coil
Replies
14
Views
468
RJRENTON
RJRENTON
Gentleman
Wiring Harness Tags for a 68 Charger
Replies
0
Views
663
Gentleman
Gentleman
Auto Transport Service
Back
Top