• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Ideas to get the balancer on the last 1/2" or so

Are you sure its a BB balancer. I think you have a small block balancer Small blocks use a longer hub 2.86 vs 2.18. I think they have the same diameter at 1.53 Also the timing tape is on backwards.
 
Last edited:
That's a good call out. It is bb and I tried a second one I had as well, too tight.
I did lock a caliper on the snout (I can't reliably use a mic) and the old balancer is smaller as well. It came off really hard. Will need to take both and the caliper to a machine shop I guess
 
You can easily take a Dremel and a sanding drum and polish the inside. Then a little anti seize.
 
Auto Transport Service
Back
Top