65 Steering wheel help

jimbosride · May 19, 2021

Putting the new wheel on the Coronet. I lined up the splines on the column like some of the threads from this form, but how can you tell if the wheel key way lines up with the shaft key way> I cannot see it or feel it even after making scribe marks. Any help would be cool.

493 Mike · May 20, 2021

Aligned correctly the wheel should slip on easily.
Mike

Badvert65 · May 20, 2021

Did you scribe the top of the steering shaft?

PRND21 · May 20, 2021

I’ve always just eyed it, if it doesn’t slip right on then you are off a spline or two. That’s if the splines aren’t boogered up, if they are then you need to repair them and start over.

jimbosride · May 20, 2021

ok .... guess I need to clean and check the splines. The column is out of a 64 sport fury that had power steering... but I don't think that's the issue here. The new wheel is nice but $$ . Thanks

Part Stalker · May 20, 2021

I am gathering you bought a new steering wheel? My new one didn't fit as the center hole was too small. Had a local guy (JC Auto Restorations) fix it for me as I had already had it dyed to match the rest of the interior. Haven't installed it yet but he test fit it on a column he had. Hope you don't have the same issue.

retractable · May 20, 2021

My new steering wheel did not fit right on my 64 Belvedere. I did a lot of fileing to get it to slide on far enough. I hope you have better luck. Jay

65 Steering wheel help

jimbosride

FBBO Gold Member

493 Mike

FBBO Gold Member

Badvert65

Well-Known Member

PRND21

FBBO Gold Member

jimbosride

FBBO Gold Member

Part Stalker

FBBO Gold Member

retractable

FBBO Gold Member

Similar threads