69 small block w hei

Long4door · Aug 21, 2021

Trying out a huge hei all in 1? Distributor. Its brand new , removed the wires used with orange box and my electronic distributor installed the new ... this is a 318 with j heads and air gap intake 3 " pipes runs pretty good any how what wire or wires should go to bat side of hei cap... I can guess and play around with blue and brown but would rather not

BeepBeepRR · Aug 21, 2021

Can you elaborate on the all in one distributor? Is it an MSD ready to run?

drhill · Aug 21, 2021

The red is the hot wire and the green is the tach. My distributor did not come with the connector. O'Reilly's had them in stock. This is one of the best upgrades that I have done. Bump the key and it is running.

Long4door · Aug 21, 2021

Looks like mine , so what goes to that red wire

Long4door · Aug 21, 2021

Long4door · Aug 21, 2021

Long4door said:
View attachment 1155676 View attachment 1155677

The brown and blue paired in factory connector have 12 volts at cranking the other 2 oddly colored blue and blue teal are 12 v at run and 5 v at cranking

drhill · Aug 21, 2021

I took the wires from the ballast resistor and put them together. This will give you 12 volts while starting and running. I did not do this at first and the car would spin over and would not fire until I let off the key. What a pain that was.

Long4door · Aug 21, 2021

drhill said:
I took the wires from the ballast resistor and put them together. This will give you 12 volts while starting and running. I did not do this at first and the car would spin over and would not fire until I let off the key. What a pain that was.

Thank you I gave that another shot and brought my timing in... good to go

69 small block w hei

Long4door

Well-Known Member

BeepBeepRR

Well-Known Member

drhill

Well-Known Member

Long4door

Well-Known Member

Long4door

Well-Known Member

Long4door

Well-Known Member

drhill

Well-Known Member

Long4door

Well-Known Member

Similar threads