AMD valve covers
- Thread starter dla4567
- Start date
The ones I bought for my MW project, 6-bolt, BB, plain, were terrible. Needed a lot of work, to make them look good, and seal.
Early offering on them, so may be better now ?
Early offering on them, so may be better now ?
MCODECUDA
Well-Known Member
I’m pretty sure they stopped offering them some time ago probably due to the fact that they weren’t right. I bought a set in chrome and bolt the holes are off.
dla4567
Well-Known Member
Says they’re in stock on their website.
MCODECUDA
Well-Known Member
I see that. It’s the chrome ones that are out of stock but unpainted ones shouldn’t fit properly also.
- Local time
- 1:32 PM
- Joined
- Jan 29, 2018
- Messages
- 19,368
- Reaction score
- 63,247
- Location
- Midland Ontario, Canada
@davek bought a set I believe.. same complaints as above..
moes
Well-Known Member
I bought a set two years ago to replace a set of Mopar Performance Black wrinkle. I had no problems with fit or sealing. They are a same copy of a friends 1970 valve covers, except the oil filler cap goes vertical instead of horizontal when it is twisted on. I can live with that.
tnfastback
Well-Known Member
I bought a set from them and had no problems or leaks 
whyjay
Well-Known Member
I ran a set on my 71 440. Same experience as mentioned above. Took several tries to get them to seal. And a couple holes were off on each side too. Finally found an original set that once repaired and painted went on the engine.
- Local time
- 11:32 AM
- Joined
- Jul 31, 2011
- Messages
- 8,980
- Reaction score
- 4,091
- Location
- Western Colorado High Desert
Sounds like a crap shoot.
I bought a set and the bolt holes were off,had to oblong then to work. Was not happy about it since it took 3 hours to install a set of valve covers.
Similar threads
